• If components are installed in a way other than as described in this section,
damage and/or device failure or electrical shock may occur.
• Do not install the drive enclosure in the rack with cables, such as power cords,
connected.
• Do not knock the other devices installed in the rack when installing drive
enclosures.
IMPORTANT
When connecting the mini SAS HD cable between enclosures, check the direction of the connector (the tab
must be pointed downward) and firmly insert all the way in.
To disconnect the mini SAS HD cables between enclosures, hold the tab and then pull out the connector.
The following figure shows how the mini SAS HD cables between enclosures are connected when drive enclosure
2 is added.
4. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
36 Operation Guide (Basic)
To Next Page
Loading...
