Chapter 2 Installation
2.3 Installing in a Rack
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
41
4 Attach the shelf plate to the AC sensor unit.
Use two M4 cross recessed head screws with captive washer to attach the shelf plate to the AC sensor
unit.
5 Attach the shelf plate to the rack.
Use four M6 cross recessed head screws with captive washer to fasten the shelf plate in the rack.
Up to two AC sensor units can be attached to the same shelf plate. Attach the first AC sensor unit on
the right side when facing the shelf plate as shown in the figure above.
M4 cross recessed head screws with captive washer
Shelf plate
(Rear rack pillars)
M6 cross recessed head screws
with captive washer
M6 cross recessed head screws
with captive washer
To Next Page
Loading...
