8.1.2.3 CA Port Group Creation
Create a CA port group for a host to access the
ETERNUS AF.
A CA port group is a group of host interface ports that have the same interface and connect to the specific
host group.
The procedure to create a CA port group is as follows:
1 Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the [Connectivity]
screen, click [Port Group] in [Category].
The [CA Port Group] screen appears.
2 In [Action], click [Create iSCSI Port Group].
The [Create iSCSI Port Group] screen appears.
3 In the [Create iSCSI Port Group] screen, enter the name of the CA port group that is to be created, select
the checkbox for the ports that are to be registered in the CA port group, and click the [Create] button.
A confirmation screen appears.
4 Click the [OK] button.
The CA port group is created and the setting completion screen appears.
5 Click the [Done] button.
The screen display returns to the [CA Port Group] screen.
Chapter 8 SAN Connection Settings
8.1 Connection Settings for the ETERNUS AF
114
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
