Event Notification
When an error occurs in the
ETERNUS AF, the event notification function notifies the event information to the
administrator. The administrator can be informed that an error occurred without monitoring the screen all the
time.
The methods to notify an event are e-mail, SNMP Trap, syslog, remote support, and host sense.
Figure 46 Event Notification
SNMP
manager
Mail
server
Syslog server
Remote
suppor
t
center
REMCS/AIS Connect
Host sense
Server (host)
SyslogSNMP TrapE-mail
ETERNUS AF
The notification methods and levels can be set as required.
The following events are notified.
Table 29 Levels and Contents of Events That Are Notified
Level Level of importance Event contents
Error Maintenance is necessary Component failure, temperature error, end of
battery life (*1), rebuild/copyback, etc.
Warning Preventive maintenance is neces-
sary
Module warning, battery life warning (*1),
etc.
Notification (information) Device information Component restoration notification, user log-
in/logout, RAID creation/deletion, storage
system power on/off, firmware update, etc.
*1: Battery related events are notified only for the ETERNUS AF250 S2.
● E-Mail
When an event occurs, an e-mail is sent to the specified e-mail address.
The ETERNUS AF supports "SMTP AUTH" and "SMTP over SSL" as user authentication. A method can be selected
from CRAM-MD5, PLAIN, LOGIN, or AUTO which automatically selects one of these methods.
● Simple Network Management Protocol (SNMP)
Using the SNMP agent function, management information is sent to the SNMP manager (network management/
monitoring server).
1. Function
Operation Management/Device Monitoring
82
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Design Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1822-09ENZ0
To Next Page
Loading...
