Fujitsu ETERNUS AF250 S2 - CA Port Group Creation; LUN Group Addition

■
CA Port Group Creation
Create a CA port group for a host to access the
ETERNUS AF.
A CA port group is a group of host interface ports that have the same interface and connect to the specific host
group.
The procedure to create a CA port group is as follows:
1 Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen, and then click "Port Group"
in [Category].
The [CA Port Group] screen appears.
2 In [Action], click the [Create CA Port Group] that corresponds to the host interface of the port group that is
to be added.
The [Create CA Port Group] screen appears.
3 In the [Create CA Port Group] screen, enter the name of the CA port group that is to be created, select the
checkbox for the ports that are to be registered in the CA port group, and click the [Create] button.
A confirmation screen appears.
4 Click the [OK] button.
The CA port group is created and the setting completion screen appears.
5 Click the [Done] button.
The screen returns to the [CA Port Group] screen.
■
LUN Group Addition
Add a group of volumes that can be recognized by the host (LUN group).
For each LUN group, volume numbers are assigned for the Logical Unit Numbers (LUNs) that are recognized by
the host.
The procedure to create a LUN group is as follows:
1 Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen, and then click "LUN Group"
in [Category].
The [LUN Group] screen appears.
2 In [Action], click [Add LUN Group].
The [Add LUN Group] screen appears.
5. Component Expansion/Function Enhancement
Adding Servers
70
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1842-06ENZ0