Fujitsu ETERNUS AF250 - Figure 54 Targets for the Multi-Copy Function; Figure 55 Multi-Copy

● Multi-Copy
Multiple copy destinations can be set for a single copy source area to obtain multiple backups.
In the multi-copy shown in Figure 54, the entire range that is copied for copy session 1 will be the target for the
multi-copy function.
When copy sessions 1 and 2 are EC/REC, updates to area A in the copy source (update 1) are copied to both copy
destination 1 and copy destination 2.
Updates to areas other than A in the copy source (update 2) are copied only to copy destination 2.
Figure 54 Targets for the Multi-Copy Function
Copy source
Copy session 1
Copy session 2
Copy destination 1
Copy destination 2
Update 1
Update 2
A
Up to eight OPC, QuickOPC, SnapOPC, EC, or REC sessions can be set for a multi-copy.
Figure 55 Multi-Copy
Copy
destination 1
Copy source
Copy
destination 2
Copy
destination 3
Copy
des
tination 4
Copy
des
tination 5
Copy
destination 6
Copy
destination 7
Copy
des
tination 8
ETERNUS DX/AF
ETERNUS DX/AF
ETERNUS DX/AF
1. Function
Backup (Advanced Copy)
94
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Design Guide (Basic)
Copyright 2019 FUJITSU LIMITED
P3AG-1822-09ENZ0