10.3 VTL Configuration
Figure 155: Media Unload Page
To unload virtual tape cartridges:
1. In the Partition drop-down box, select the partition that contains the cartridges to
unload.
2. If the partition is online, click Offline to take the partition offline. To unload media,
the partition must be offline.
3. In the Show Location drop-down box, select the type of location you want to unload
cartridges from (Drive, I/E Slot).
4. (Optional) If you are unloading cartridges from a drive, select the Force Unload
(Virtual Tape Drives) check box to force drives to unload the cartridges before ejecting
them.
5. (Optional) To reduce the number of cartridges displayed in the table, enter a barcode
or barcode range in the Barcode Filter box and click Apply Filter.
Use a hyphen (-) to indicate a range, and use an asterisk (*) to indicate a wildcard.
Separate multiple entries with commas, and do not use spaces.
Example: Enter AAA* to display all cartridge barcodes beginning with AAA. Or enter
AAA010-AAA020 to display all barcodes in the specified range. Click the Quick Tip
icon [?] for additional examples.
6. Select the cartridges to unload.
If necessary, use the controls at the bottom of the table to navigate between
multiple pages of results. Select the number of rows to display in the Show
drop-down box.
7. Click Apply.
ETERNUS CS800 219
To Next Page
Loading...
