Fujitsu ETERNUS CS800 S6 - Page 222

10.3 VTL Configuration
Adding a Remote Host Access Group
Add a host access group to associate a VTL partition with a host (a Fibre Channel initiator
on the SAN) and a target (a Fibre Channel port on the ETERNUS CS800).
To add a host access group:
1. Click Add.
The Map Remote Hosts, Define Groups page displays (see "Map Remote Hosts, Define
Groups Page" on page 222).
Figure 157: Map Remote Hosts, Define Groups Page
2. Enter information about the host access group:
Group Name Enter a name for the group.
Partition Select the partition to associate with the group.
Remote Host Select the host (initiator) to associate with the
group.
You must configure a host before it is available
in the Host drop-down box (see "Remote Hosts"
on page 224).
ETERNUS CS800 222