10.3 VTL Configuration
Figure 158: Edit Remote Host Mapping Page
2. (Optional) Select the Use CCL check box to use the Command and Control LUN.
The CCL (Command and Control LUN) is not used in most environments. This
option is recommended for host access groups that contain an HP-UX host.
It can also be used if hosts that are not assigned to any host access group
exist in the SAN. The CCL is accessible to hosts only through LUN 0.
CAUTION!
If you are not sure if you should use CCL, contact Fujitsu Technology Solutions
Customer Support before you enable this option.
3. Select the check boxes for the media changer and tape drives to add to the host access
group.
The LUN assignment displays next to the device.
4. Click Apply.
Deleting a Remote Host Access Group
Delete a host access group if it is no longer needed.
To delete a host access group:
1. Select the group and click Delete.
You can select multiple groups to delete at once.
2. Click Yes to confirm the deletion.
Remote Hosts
Use the Remote Hosts page to discover and add Fibre Channel hosts to the available host
list for the ETERNUS CS800.
ETERNUS CS800 224
To Next Page
Loading...
