Fujitsu ETERNUS CS800 S6 - Page 282

10.8 Notifications
IP Address Enter the IP address of the system that will receive
the traps generated by the ETERNUS CS800.
Additional Information
l When entering IP addresses, never use an address
that is in a reserved IP address range. To see a
list of reserved IP address ranges, click the quick
tip icon [?] located near the IP address field.
l To use hostname format, you must specify at
least one DNS IP address on the Network page
(see "Network" on page 293).
Name Enter the name of the destination.
3. Select one or more traps to send to the destination:
Failure Sends failure traps.
Warning Sends warning traps.
Informational Sends informational traps.
Available Sends a trap when the system transitions from an
unavailable to an available state.
Unavailable Sends a trap when the system transitions from an
available to an unavailable state.
4. Click Apply.
Editing a Destination
Edit an SNMP destination to change the name of the destination or the types of traps the
ETERNUS CS800 sends to the destination.
To edit a destination:
1. Select SNMP destination and click Edit.
The Edit Trap Destination page displays (see "Edit Trap Destination Page" on page
283).
ETERNUS CS800 282