Initial Configuration Creating a Typical Backup Configuration
U41842-J-Z125-1-76 95
Dokuschablonen qua19x24 Version 1.1us für FrameMaker V7.x vom 25.03.2010 © cognitas GmbH 2001-2010
1. April 2010 Stand 11:05.10 Pfad: G:\allgemein\CS800\1000500_FTS-Doku\1000502_GettingStartedGuide\GettingStarted.k08
b) Select Administrator, type spcc for the password, and click Login.
The Home page displays,
Figure 71: Home Screen
V
CAUTION!
Please change the default password immediately (Configuration > Security).
I
Information on the field Status (Attention is highlighted yellow):
The DX80 is preconfigured in the factory and a Background Initialize is started. This
Background Initialize continues to run on the customer side. Depending on the
configuration (number of storage modules), it can run for between one and several
days. This is NOT AN ERROR.
Further information is provided in section "Background Initialize" on page 99.
Creating a Typical Backup Configuration
Before you can begin using the ETERNUS CS800 for backups, you must configure the
system for NAS or Symantec™ NetBackup OST. See the following sections for detailed
instructions for completing each type of configuration:
● "NAS configuration" on page 96
See this section to configure the ETERNUS CS800 to use OST (OpenStorage) and
Symantec Veritas NetBackup to perform backups and Optimized Duplication.
● OST configuration
For OST configuration see ETERNUS CS800 User Guide.
To Next Page
Loading...
