Fujitsu ETERNUS DX S5 Series - Eternus Dx100 S5;Dx200 S5; Figure 144 Front View of a 2.5 Type Controller Enclosure (ETERNUS DX100 S5;DX200 S5); Figure 145 Front View of a 3.5 Type Controller Enclosure (ETERNUS DX100 S5;DX200 S5)

ETERNUS DX100 S5/DX200 S5
The ETERNUS DX100 S5/DX200 S5 controller enclosure contains drives installed in the front, and controllers and
power supply units in the rear.
Two types of controller enclosures are available: a 2.5" type and a 3.5" type.
● Front View
Figure 144 Front View of a 2.5" Type Controller Enclosure (ETERNUS DX100 S5/DX200 S5)
Slot#0 Slot#1 Slot#2 Slot#3 Slot#4 Slot#5 Slot#6 Slot#7 Slot#8 Slot#9
Slot#10 Slot#11 Slot#12 Slot#13 Slot#14 Slot#15 Slot#16 Slot#17 Slot#18 Slot#19 Slot#20 Slot#21 Slot#22 Slot#23
1
3 3
2
Figure 145 Front View of a 3.5" Type Controller Enclosure (ETERNUS DX100 S5/DX200 S5)
1
3 3
2
Slot#0 Slot#3Slot#1 Slot#2
Slot#4
Slot#8
Slot#11
Slot#7Slot#5
Slot#6
Slot#9 Slot#10
1 Operation panel
An operation panel has LEDs, a Power switch, and a FUNCTION button.
2 2.5" drive or 3.5" drive
(Refer to "
■ Drives" (page 265).)
3 Flange cover
6. Hardware Configurations
Controller Enclosure
249 Design Guide