Fujitsu ETERNUS DX S5 Series - Drive Enclosure; External Views of a Drive Enclosure; Figure 162 Front View of a 2.5 Type Drive Enclosure; Figure 163 Front View of a 3.5 Type Drive Enclosure

Drive Enclosure
This section explains the main components in the drive enclosure.
The drive enclosure contains drives installed in the front, and I/O modules and power supply units in the rear.
There are three types of drive enclosures that correspond to available drive sizes (2.5", 3.5", and high-density
3.5").
Drive enclosures can be added during system operation. When an error occurs, replacement operations can be
performed while the system is running.
External Views of a Drive Enclosure
■
Front View of a Drive Enclosure
Figure 162 Front View of a 2.5" Type Drive Enclosure
Slot#0 Slot#1 Slot#2 Slot#3 Slot#4 Slot#5 Slot#6 Slot#7 Slot#8 Slot#9
Slot#10 Slot#11 Slot#12 Slot#13 Slot#14 Slot#15 Slot#16 Slot#17 Slot#18 Slot#19 Slot#20 Slot#21 Slot#22 Slot#23
1
3 3
2
1 Operation panel
An operation panel has a DE-ID display and LEDs.
2 2.5" drive
(Refer to "■ Drives" (page 272
).)
3 Flange cover
Figure 163 Front View of a 3.5" Type Drive Enclosure
1
3 3
2
Slot#0 Slot#3Slot#1 Slot#2
Slot#4
Slot#8
Slot#11
Slot#7Slot#5
Slot#6
Slot#9 Slot#10
1 Operation panel
An operation panel has a DE-ID display and LEDs.
2 3.5" drive
(Refer to "■ Drives" (page 272
).)
3 Flange cover
6. Hardware Configurations
Drive Enclosure
266 Design Guide