Function Specifications
This section contains the specifications of the functions for the ETERNUS DX.
Volume Specifications
This section describes the volume specifications of the ETERNUS DX.
Table 120 Volume Specifications
Item DX60 S5 DX100 S5 DX200 S5 DX500 S5 DX600 S5 DX900 S5
Supported RAID levels 0 (*1), 1, 1+0, 5, 5+0, 6, 6-FR (*2)
RAID group Number of RAID
groups (max.) (*3)
48 72 132 288 528 1,152
Number of volumes
per RAID group
(max.)
128
Thin Provisioning
Pool (TPP)
Number of pools
(max.)
48 72 132 256 256 256
Number of volumes
per pool (max.) (*4)
1,023 4,095 8,191 16,383 16,383 65,534
Volume Number of volumes
(max.)
1,024 4,096 8,192 16,384 16,384 65,535
Volume capacity
(max.)
128TB
Number of
connectable SAN
hosts (HBAs) (max.)
Per ETERNUS DX 128 1,024 1,024 4,096 4,096 8,192
Per port 32 256 256 256 256 256
*1: Use of RAID0 is not recommended because it is not redundant. For RAID0 configurations, data may be lost due to the failure of a single
drive.
*2: Fujitsu original RAID level that provides the high speed rebuild function, and striping with double distributed parity.
*3: The maximum number of RAID groups that can be registered (for the RAID1 configuration).
*4: The maximum number of volumes that can be created in a TPP is calculated by subtracting the number of RAID groups that configure the
relevant TPP from the maximum number of volumes that can be created in the
ETERNUS DX.
A. Specifications
Function Specifications
318 Design Guide
To Next Page
Loading...
