Fujitsu ETERNUS DX S5 Series - Table 127 Combinations of Functions that Can be Executed Simultaneously (2;2)

Table 127 Combinations of Functions That Can Be Executed Simultaneously (2/2)
Process to be run
Already running process
Volume
Conversion
Encryption
Disk Drive
Patrol
Eco-mode
(motor is
stopped)
TPV
Balancing
TPV/FTV
capacity
optimization
Storage
Cluster
Volume
formatting
¡ (*3) ¡ ¡ (*12) ¡ (*4) ¡ ¡ (*4)
RAID Migration
¡ (*4) ¡ ¡ (*12) ¡ (*4) ¡ (*4) ¡
Logical Device
Expansion
¡ (*7) ¡ ¡ (*12) ¡ ¡ ¡
LUN
Concatenation
¡ (*4) ¡ ¡ (*12) ¡ ¡ ¡ (*4)
Advanced Copy
(*2)
¡ ¡ ¡ (*13) ¡ ¡ ¡
Volume
Conversion
Encryption
¡ (*4) ¡ ¡ (*12) ¡ ¡ ¡
Switching the
controlling CM
¡ (*7) ¡ ¡ ¡ ¡ ¡
TPV capacity
expansion
¡ ¡ ¡ (*12) ¡ (*4) ¡ ¡
TPV Balancing
¡ ¡ ¡ (*12) ¡ (*4) ¡ (*4) ¡
TPV/FTV capacity
optimization
¡ ¡ ¡ (*12) ¡ (*4)
´
¡
FTRP Balancing
¡ ¡ ¡ (*12) ¡ (*4) ¡ (*4) ¡
¡: Possible, ´: Not possible
*1 : This indicates that the copy session is being set or the copy session is already set.
*2 : This indicates the copy session setting operation.
*3 : Volume formatting will cause losing the entire data in volumes.
*4 : The function cannot be executed when the same volume is set as the execution target.
*5 : LUN concatenated volumes can be set as the RAID Migration source.
Note that LUN concatenated volumes cannot be set as the RAID Migration destination.
*6 : RAID Migration that expands the capacity cannot be performed on any volumes with copy sessions in LUN units.
*7 : The function cannot be executed when the same RAID group is set as the execution target.
*8 : When a copy session with a copy area that is specified in LUN units exists, volume capacity expansion cannot be performed because
copying cannot be processed for the expanded part. When a copy session is specified for a logical disk, volume capacity expansion can
be performed.
*9 : Copy sessions in LUN units cannot be performed on a volume that is being expanded with RAID Migration.
*10: Complies with Advanced Copy specifications (multi-copy/Cascade Copy).
*11: The REC session needs to be suspended or stopped before the operation.
*12: The motor-off state of Eco-mode is stopped, and the drive motor is activated (spin-up).
*13: EC/REC can be performed (the motor-off state of Eco-mode will be stopped).
OPC/QuickOPC/SnapOPC/SnapOPC+ cannot be performed (the
ETERNUS DX returns an error).
B. Function Specification List
Combinations of Functions That Are Available for Simultaneous Executions
326 Design Guide