(3) Enter the IP address of SNMP Manager (monitoring server) and click the [OK] button.
The screen returns to the manager list of the [Setup SNMP Manager] screen.
(4) Check the SNMP Manager that was added in Step (3) is displayed in the manager list and click the
[Set] button.
A confirmation screen appears.
(5) Click the [OK] button.
The SNMP Manager settings are applied.
(6) Check the setting completion message and click the [Done] button.
The screen returns to the [Network] screen.
4 Set up a community or a user.
Set up the community or the user that is used for SNMP Trap.
Note
• To use SNMPv1 or SNMPv2c, perform the "Setup SNMP Agent Community" settings. To use
SNMPv3, perform the "Setup SNMP Agent User" settings.
• To use ETERNUS SF Storage Cruiser for management, perform the "Setup SNMP Agent Community"
settings to use SNMPv1.
n Community setup
(1) Click [Setup SNMP Community] in [Action].
The [Setup SNMP Agent Community] screen appears.
(2) In the community list of the [Setup SNMP Agent Community] screen, click the [Add] button.
8. Monitoring Settings
Various Notification Settings
163 Configuration Guide (Basic)
To Next Page
Loading...
