High-density drive enclosure
Front/Rear
4U
Rack rail
High-density drive
enclosure base line
[Right][Left]
2nd hole
(M4 screw)
2nd hole
(M4 screw)
3 Install the stopper bracket (for left side) and the stopper bracket (for right side).
Attach the stopper bracket to the front rack pillar.
Stopper bracket
(left)
(Rack pillar: front)
Rack rail
(right)
Rack rail
(left)
M5 screw
M5 screw
(Rack pillar: rear)
Stopper bracket
(right)
The M5 screw positions for the stopper brackets are determined by the high-density drive enclosure base
line.
Insert the M5 screws in the seventh holes above the base line to fasten the stopper brackets.
4U
Rack rail
High-density drive
enclosure base line
7th hole
(M5 screw)
High-density drive enclosure
Front
[Right][Left]
7th hole
(M5 screw)
4 Install the flap brackets.
Attach flap bracket A and B on the right side of the rear rack pillar with the M4 screws.
3. Rack Installation
High-Density Drive Enclosure Installation
42 Configuration Guide (Basic)
To Next Page
Loading...
