M4 screw
(Rack pillar: front)
(Rack pillar: rear)
Rack rail
(left)
Rack rail
(right)
Stopper bracket A
Stopper bracket B
The M4 screw positions for flap bracket A and B are determined by the high-density drive enclosure base
line.
Insert the M4 screws in the seventh and eighth holes above the base line to fasten the flap brackets.
4U
Rack rails
High-density drive
enclosure base line
7th & 8th
holes
(M5 screws)
Rear view of a high-density drive enclosure
[Right][Left]
Flap bracket B
5 Install the high-density drive enclosure in the rack.
• For safety and stability, use a lifter to install or remove high-density drive
enclosures in the rack.
6 Fasten the high-density drive enclosure in the rack.
Use four M5 screws to fasten it in the rack pillar.
3. Rack Installation
High-Density Drive Enclosure Installation
43 Configuration Guide (Basic)
To Next Page
Loading...
