(3) Swing the lock lever in the direction of the arrow, until the lock clicks shut.
(4) Check the status of the LED on the Disk Activity Panel (DAP) of the added drive.
11 To install more additional drives, repeat Step 9 and Step 10.
12 Close the top board.
13 Insert the high-density drive enclosure all the way into the rack while pulling the stopper catches on
both sides of the high-density drive enclosure back.
14 Push the stopper catches to lock the high-density drive enclosure.
15 Fasten the high-density drive enclosure to the rack pillar with the M4 screws that were removed in Step
4.
16 Attach the front cover.
17 If a wrist strap is used, remove the wrist strap.
18 In the [Drives] screen of [Component] on the ETERNUS Web GUI screen, check that the added drives
have been recognized.
19 Set up RAID groups, volumes, hot spares, and host affinity settings, as required.
Chapter 5
Component Expansion/Function Enhancement
5.1 Installing Additional Drives
78
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
