3 Wear a wrist strap or touch a metal part to discharge the human body's natural static electricity.
4 Install the drive enclosure in the rack.
• 2.5"/3.5" type drive enclosures (for regions other than the EMEIA, North American, Central American,
and Caribbean regions)
(1) Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the
front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be
attached to the rack before they can be completely tightened.
(Rear view of rack pillar)
(Front view of rack pillar)
Loosen the M4 screws to
adjust the length of the rack
rails to match the distance
between the front and
rear rack pillars.
Rack rail (left)
"L" indicated inside
Rack rail (right)
"R" indicated inside
[Left]
[Right]
(2) Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the
rack rails to the rear rack pillars.
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any
space between them.
(Front view of rack pillar)
(Rear view of rack pillar)
Washer
M5 screw
M5 screw
Washer
M5 screw
Plate
M5 screw
Plate
Rack rail (right)
Rack rail (left)
The M5 screw positions for the rack rails are determined by the drive enclosure base line.
Chapter 5
Component Expansion/Function Enhancement
5.2 Installing Additional Drive Enclosures
84
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
