Fujitsu ETERNUS DX100 S3 - Page 85

Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in
the 2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
Front view of drive enclosure
Rear view of drive enclosure
2U
Rack rail
[Right][Left]
2U
Rack rail
[Right][Left]
Sixth screw
(M5 screw)
First screw
(M5 screw)
First screw
(M5 screw)
Fifth screw
(M5 screw)
Fifth screw
(M5 screw)
Second screw
(M5 screw)
Second screw
(M5 screw)
Sixth screw
(M5 screw)
Bottom position of
drive enclosure
Bottom position of
drive enclosure
(3) Tighten the M4 screws of the rack rails that were slightly unscrewed in Step (1).
(4) Install the drive enclosure in the rack.
Do
- When installing or removing the drive enclosure to or from the rack,
make sure that the sides and the bottom of the drive enclosure are
held by two or more people. Failure to do so may cause injury.
Chapter 5
Component Expansion/Function Enhancement
5.2 Installing Additional Drive Enclosures
85
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0