(7) Attach the flange cover.
• High-density drive enclosures (for regions other than the EMEIA, North American, Central American,
and Caribbean regions)
(1) Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Pull the rail lock lever in the direction of the arrow and unlock it to adjust the length of the rack
rails to match the distance between the front and the rear rack pillars. Leave the rail lock lever
unlocked because the rail lock lever is locked after the rack rail is installed.
Rail lock lever
Unlock the levers to adjust the length of the
rack rails to match the distance between the
front and rear rack pillars.
Rack rail (left)
"Left" is on the exterior
[Left]
[Right]
Rack rail (right)
"Right" is on the exterior
(Rack pillar: front)
(Rack pillar: rear)
Chapter 5 Component Expansion/Function Enhancement
5.2 Installing Additional Drive Enclosures
87
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
