Chapter 1 System Management
1.15 Firmware Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
221
7 Click the [Apply] button.
A confirmation screen appears.
8 Click the [OK] button.
■ When the application mode is "Update"
■ When the application mode is "Update & Reboot"
Application of the controller firmware starts.
"Update" or "Update & Reboot" is displayed as the application mode. Which one is displayed depends
on the storage system status. If "Update & Reboot" is displayed and the [Apply] button is clicked, the
ETERNUS DX automatically reboots after the controller firmware is applied.
Click the [Rediscovery] button to display the latest information, the application mode, and the status
check result.
Never turn off the ETERNUS DX while controller firmware is being applied. Wait until the application of
the controller firmware is complete.
To Next Page
Loading...
