Fujitsu ETERNUS DX100 S3 - Page 623

Chapter 7 Advanced Copy Management
7.8 REC Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
623
The main setting items are as follows.
● Copy Path Setting
• Line Setting
● Line Setting
• Connection Type
• Link Speed
3 Click the [OK] button.
 The [Copy Path Creation Storage System Selection] screen appears.
4 Repeat Step 1 through Step 3 the same number of times as the number of storage systems
to set copy paths.
5 When setting a copy path is completed for all the storage systems, click the [Next >>]
button.
 The [Storage System Connection List] screen appears. Proceed to "Apply Copy Path Information"
(page 627).
If an error screen appears under the following conditions, check the parameter settings.
• The number of remote storage systems exceeds the maximum
• The number of paths per port exceeds the maximum