Fujitsu ETERNUS DX100 S3 - A.3.6 Set Allocation

Appendix A Parameter List
A.3 Volume Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
799
A.3.6 Set Allocation
For details about this function, refer to "3.7.8 Set Allocation" (page 295).
For the factory default settings for this function, refer to "Appendix B Set Allocation" (page 989)
.
● Allocation Settings
• Allocation
A.3.7 Start RAID Migration
For details about this function, refer to "3.9 Start RAID Migration" (page 301).
For the factory default settings for this function, refer to "Appendix B Start RAID Migration" (page 989)
.
● Setting Volume
• Migration Destination
Description Select the allocation method.
Input condition/
Display contents
• Thin
• Thick
Regardless of the allocation method (Thin or Thick) of the selected volume, "Thin" is selected when this function
starts.
Description Select the migration destination of the volume.
Input condition/
Display contents
• RAID Group / Thin Provisioning Pool / Flexible Tier Pool
• Wide Striping Volume
• In the following conditions, select "RAID Group / Thin Provisioning Pool / Flexible Tier Pool" for "Migration
Destination".
- An ODX Buffer volume is selected as a migration source volume.
- A NAS user volume, a NAS backup volume, or a NAS system volume is selected as a migration source volume
(only "Thin Provisioning Pool" can be selected as the migration destination.)
- A migration source FTV usage is "System"
(only "Flexible Tier Pool" can be selected as the migration destination.)
• For the volume used by the Storage Cluster function, the type (Standard/WSV/TPV/FTV) cannot be changed.
Select the migration destination to match the migration source volume type.