Fujitsu ETERNUS DX100 S3 - Page 953

Appendix A Parameter List
A.7 Advanced Copy Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
953
● Bandwidth Limit Settings
• Setting Mode
• Bandwidth Limit
● Advanced Copy Path
• Bandwidth Limit
If the created path information and the path information in the ETERNUS Disk storage system do not match and
some of the copy paths to the ETERNUS Disk storage system are not selected to be applied (clear the Box ID
checkbox), the actual path information after application does not correspond to the backed up path information
file. Refer to "Specification for applying result" (page 954)
for details.
• Even when "Result of applying" is "Delete" for the path, the applying result is changed to "Do not Change" when
the checkbox for selecting the Box ID is cleared. If the created path information is applied under this condition,
the relevant path is not deleted. The path information is merged in the ETERNUS Disk storage system.
• When "Result of applying" is "Do not Change" for a path, the checkbox for selecting a Box ID is selected. In this
case, the checkbox cannot be cleared.
Description Select a bandwidth setting mode.
Input condition/
Display contents
• Set the same Bandwidth Limit for all paths
• Set the Bandwidth Limit for each path
Description When "Set the same Bandwidth Limit for all paths" is selected for the setting mode,
enter the bandwidth limit.
When "0" is entered, the bandwidth limit is "Unlimited".
When "Set the Bandwidth Limit for each path" is selected for the setting mode, the field
is blank. Set the bandwidth limit for each path in the "Advanced Copy Path" field.
Input condition/
Display contents
• 0 - 65535 [Mbit/s]
• Blank
Description Enter the bandwidth limit for each path.
When "0" is entered, the bandwidth limit is "Unlimited".
Input condition/
Display contents
0 - 65535 [Mbit/s]