Fujitsu ETERNUS DX100 S4 - Figure 26 Connection Example 2 (Connections in Multiple Racks)

● Installing Enclosures in Multiple Racks (When Only One Controller Is Installed)
This section describes a connection configuration in which the enclosures are installed in multiple racks.
The following figure shows an example when one controller enclosure and eight 2U drive enclosures are distrib-
uted between two racks. Obtaining extra extension cables for these connections between the racks is required.
Figure 26 Connection Example 2 (Connections in Multiple Racks)
DE#02 (2U)
DE#01 (2U)
CE
DE#06 (2U)
DE#05 (2U)
DE#08 (2U)
DE#07 (2U)
DE#04 (2U)
DE#03 (2U)
Extension cables
3.5m/6.0m/15m/30m
Connections in the same rack are omitted in the above figure.
2. Rack Installation Specifications
Rack Installation Requirements
49
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems
Site Planning Guide
Copyright 2021 FUJITSU LIMITED
P3AM-7632-18ENZ0