Installable Racks
This section explains the racks in which the
ETERNUS DX can be installed.
Fujitsu Racks
The ETERNUS DX can be installed in a Fujitsu 19-inch rack. For information about whether the ETERNUS DX can
be installed in an EOLed rack or not, contact your sales representative.
Non-Fujitsu Racks
The ETERNUS DX storage systems are developed and their operation is guaranteed on the assumption that they
are installed in Fujitsu 19-inch racks. Since the
ETERNUS DX cannot be tested (for cooling and strength) in non-
Fujitsu 19-inch racks, the operations of ETERNUS DX storage systems cannot be guaranteed. Any problem that
may occur by installing the ETERNUS DX in non-Fujitsu racks is not covered by the warranty.
If the ETERNUS DX needs to be installed in a non-Fujitsu rack, the following conditions must be satisfied.
■
Rack Specifications
Use the rack mount kit supplied with the product to install the ETERNUS DX in the rack. The rack specifications
must satisfy the conditions listed below. For rack specifications, refer to the manual for the rack that is used.
•
Pitch for mounting holes
EIA Standard Universal pitch
•
Size for mounting holes
The size of the square holes must be 9mm or more.
•
Load bearing capacity
The load bearing capacity must be equal to or larger than the total weight of the ETERNUS DX.
•
Unit Installation Area
The dimensions of the area shown in Figure 31 must match the conditions described in Table 23.
2. Rack Installation Specifications
Installable Racks
54
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems
Site Planning Guide
Copyright 2021 FUJITSU LIMITED
P3AM-7632-18ENZ0
To Next Page
Loading...
