Fujitsu ETERNUS DX100 S5 - Figure 128 Enclosure Connection Path (When Only One Controller Is Installed); Figure 129 Enclosure Connection Path (When Two Controllers Are Installed)

● ETERNUS DX100 S5/DX200 S5
Connect the controller enclosure to the drive enclosure as shown in the following figures.
Connection paths are not duplicated when only one controller is installed.
Figure 128 Enclosure Connection Path (When Only One Controller Is Installed)
DE #0x
CE
DE #01
DE #02
DE #0A
DI
DI (IN)
DI (OUT)
DI (IN)
DI (OUT)
DI (IN)
DI (OUT)
DI (OUT): Drive interface (OUT) port
DI (IN): Drive interface (IN) port
Figure 129 Enclosure Connection Path (When Two Controllers Are Installed)
DE #0x
CE
DE #01
DE #02
DE #0 A
DI
DI (IN)
DI (OUT)
DI (IN)
DI (OUT)
DI (IN)
DI (OUT)
DI (IN)
DI (OUT)
DI (IN)
DI
DI (IN)
DI (OUT)
DI (OUT)
DI (OUT): Drive interface (OUT) port
DI (IN): Drive interface (IN) port
6. Hardware Configurations
Configuration Schematics
238 Design Guide