● Rear View
Figure 154 Rear View of a Controller Enclosure (ETERNUS DX900 S5)
9 9
1 1
5 643
10 10
7 8
CPSU#0
CPSU#1
CA#0
CA#1
CA#0
CA#1
CA#2
CA#3CA#2
CA#3
2 2
CM#0
CM#1
BUD#1
BUD#0
BUD#1
BUD#0
1 Controller (CM#0, CM#1)
(Refer to "Controllers" (page 257
).)
2 Host interface (CA#0, CA#1, CA#2, CA#3)
(Refer to "■ Host Interfaces" (page 259).)
3 RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to "■ MNT Ports/RMT Ports/FST Ports" (page 263).)
4 MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to "■ MNT Ports/RMT Ports/FST Ports" (page 263).)
5 FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
(Refer to "■ MNT Ports/RMT Ports/FST Ports" (page 263).)
6 Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to "■ Drive Interface Ports" (page 263).)
7 FRT port
This port is used to connect CMs and FRTs.
8 SVC port
This port is used to connect CMs and SVCs.
9 Power supply unit (CPSU#0, CPSU#1)
(Refer to "■ Power Supply Units" (page 264).)
10 BUD (BUD#0, BUD#1)
(Refer to "■ BUD" (page 258).)
6. Hardware Configurations
Controller Enclosure
256 Design Guide
To Next Page
Loading...
