Copyright Fujitsu Technology Solutions, Release September 2011
Hardware and Software Installation ETERNUS DX60 S2
Power On Procedure
Power on ETERNUS from Controller Enclosure
Push the Power Switch
If everything is OK, the READY LED will go green in about three minutes
LEDs
POWER
• Green when the power is turned on
READY
• Green when the system is available for use
FAULT
• Steady orange when a malfunctioning system
component has been detected
• Blinking orange when a preventive replacement of
a system component is required
IDENTIFY
• Blinking blue when turned on from the
management software
CACHE
• Steady green when the cache is in use
• Blinking green when a power failure has occurred
and the cache data has been stored in the
CompactFlash memory
13
To Next Page
Loading...
