Fujitsu ETERNUS DX60 S2 - Start; End Maintenance

13
FUJITSU Storage ETERNUS DX60 S2 Disk storage system Read Me First
Copyright 2014 FUJITSU LIMITED
P3AM-5542-07EN
Perform the ETERNUS DX Disk storage system monitoring setup if required.
●
Notication of the ETERNUS DX Disk storage system problems as they occur is possible if the event
notication method and level have been set.
●
If remote support is required, the ETERNUS DX Disk storage system needs to be set to notify the remote
support center of failures.
Perform the settings required to connect to the server and install the required drivers. Perform the settings
required for network devices connecting the server and the ETERNUS DX Disk storage system.
After the server connection setup, conrm that the volumes in the ETERNUS DX Disk storage system can
be recognized by the server.
All necessary settings are complete, and the ETERNUS DX Disk storage system is now ready for normal
operation.
Monitoring Setup
STEP
Server Connection
STEP
Operation and Maintenance
Remote support allows prompt detection and resolution of trouble.
Point
-Installation- "5.2 ETERNUS DX Disk Storage System Monitoring Setup"
●
-Installation- "5.3 Server Connection Setup"
●
-Server Connection-
Status check
The status of the ETERNUS DX Disk storage system should be regularly monitored by checking the LEDs and using
ETERNUS Web GUI.
Data backup
Important data should be regularly backed up to a tape drive or similar device as a precaution against system failures.
Maintenance support period
The standard maintenance support period for ETERNUS DX Disk storage system is ve years from the date of purchase,
or is dened in your service level agreement (SLA). Contact your sales representative for details if you prefer to extend
the period.
●
-Operation- "4.2 Monitoring ETERNUS DX Disk Storage System Status"
●
-Operation- "6.1 Periodic Backup"
●
-Operation- "6.4 Maintenance Service"