Fujitsu ETERNUS DX60 S2 - Maintenance Operations

3
FUJITSU Storage ETERNUS DX60 S2 Disk storage system Read Me First
Copyright 2014 FUJITSU LIMITED
P3AM-5542-07EN
Check the list of package contents for the purchased product to conrm that no items are missing. Tick off the checkbox
of each conrmed item.
If there is a missing item, contact your sales representative.
●
Store the package contents in a safe and secure location, as they may be needed again when making changes to the
system or reinstalling the software.
●
Note that the package may sometimes also contain an Errata sheet and/or other such unlisted documentation.
Package Contents
*1: An alphanumerical character is used for
a
to indicate the ETERNUS DX Disk storage system model.
D : dual-controller type
S : single-controller type
An alphanumerical character is used for
b
to indicate the host interface type.
F : FC
L : iSCSI
S : SAS
An alphanumerical character may also be used for
c
depending on the purchased product.
□
Pin (x 1)
Used to adjust the Controller Enclosure's AUTO POWER
dip-switch.
□
Controller enclosure (x 1)
Drives that are purchased at the same time as the ETERNUS DX
Disk storage system are preinstalled according to the installation
rules.
●
2.5inch
●
3.5inch
□
Cover (x 1)
●
2.5inch
Flange cover
●
3.5inch
Front cover
□
M5 screw (x 8)
for attaching the rack rails
□
Screw holder (x 8)
Used when the rack pillars
have square holes.
□
Rack rail kit
□
Rack rail (x 1 set)
□
Read Me First (this document) (x 1)
□
Safety Precautions (x 1)
□
Documentation CD (x 1)
□
Network Settings label (x 1)
ETERNUS DX60 S2 (2.5inch) (Product ID: ET062
a
C
b c
U
(*1)
)
ETERNUS DX60 S2 (3.5inch) (Product ID: ET062
a
D
b c
U
(*1)
)
□
AC200V cable (x 2) IEC60320-C13↔NEMA L6-15P (4m)