Replacing a Component (2)
Replace the component according to the instructions given in
the Maintenance Manual
Typical installation times shown on the table
After the replacement Status is changed
as follows
Normal
• Installed the replacement part successfully
Maintenance
• Installing the replacement part
• Please note that for a disk drive this status combined with automatically started
Rebuild/Copyback indicates a successful replacement
Warning, Error
• Installation has failed
Copyright Fujitsu Technology Solutions, Release September 2011
Support and Maintenance ETERNUS DX60 S2
CM 10 min
EXP 5 min
SFP 1 min
PSU 2 min
Disk 1 min
SAS Cable 5 min
AC Cable 2 min
45
To Next Page
Loading...
