Fujitsu ETERNUS DX60 S3 - Figure 3.15 Power Supply Control Using Wake on LAN

■
Remote Power Operation (Wake On LAN)
Wake On LAN is a function that turns on the ETERNUS DX via a network.
When "magic packet" data is sent from an administration terminal, the ETERNUS DX detects the packet and
the power is turned on.
To perform Wake On LAN, utility software for Wake On LAN is required and settings for Wake On LAN must be
performed.
The MAC address for the ETERNUS DX can be checked on ETERNUS Web GUI.
Figure 3.15 Power Supply Control Using Wake On LAN
LAN
Packet transmission
Administration terminal
Wake On LAN utility
ETERNUS DX
Chapter 3 Functions
3.6 Operation Management
40
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Overview
Copyright 2014 FUJITSU LIMITED
P3AM-8972-01ENZ0