3 Specify the capacity in [Specify Volume Size], and click the [Next] button.
Set the capacity assuming "LUN size = drive size" for this example.
4 When [Assign Drive Letter or Path] appears, assign a drive letter and click the [Next] button.
Perform the settings as shown below.
Drive
File system
that is to be
created
LUN Volume No. Volume name Type Capacity
F NTFS 0 0 main Standard 1TB
Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
131
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
