6 Select the radio button of the volume that is to be used, and then click the [OK] button.
Select the "No.: 1, Name: sdv0" volume.
7 Check the displayed information, and then click the [Start] button.
8 In the confirmation screen, click the [OK] button.
The SnapOPC+ session starts.
9 Click the [Done] button to return to the [Advanced Copy] screen.
Chapter 9 Advanced Copy Settings
9.2 Performing a Copy (SnapOPC+)
143
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
