4 Set up a community or a user.
Set up the community or the user that is used for SNMP Trap.
• To use SNMPv1 or SNMPv2c, perform the "Setup SNMP Agent Community" settings. To use SNMPv3,
perform the "Setup SNMP Agent User" settings.
• To use ETERNUS SF Storage Cruiser for management, perform the "Setup SNMP Agent Community"
settings to use SNMPv1.
Community setup
(1) In [Action], click [Setup SNMP Community].
The [Setup SNMP Agent Community] screen appears.
(2) In the community list of the [Setup SNMP Agent Community] screen, click the [Add] button.
(3) Enter the community name, set the required items, and click the [OK] button.
The screen display returns to the community list of the [Setup SNMP Agent Community] screen.
(4) Check the community name that was set in Step (3) is added in the community list and click the
[Set] button.
A confirmation screen appears.
(5) Click the [OK] button.
The SNMP community settings are applied.
(6) Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
Chapter 6 Monitoring Settings
6.2 Various Notification Settings
85
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
