Fujitsu ETERNUS DX60 S3 - Package Size; Table 1.2 Package Size (for Regions Other than the EMEIA, North American, Central American, and Caribbean Re- Gions)

1.4 Package Size
The ETERNUS DX is shipped in cardboard boxes. These boxes may not fit through some doorways or eleva-
tors. To make sure that the ETERNUS DX can be moved to the installation site, carefully check the transport
route information.
The following table shows the package size and the maximum package weight of each component for re-
gions other than the EMEIA, North American, Central American, and Caribbean regions.
Table 1.2 Package Size (for Regions other than the EMEIA, North American, Central American, and Caribbean Re-
gions)
Component
Package size (W ´ D ´ H)
Maximum weight
Controller enclosure 2.5" type
600 ´ 760 ´ 240mm
Approximately 40kg
3.5" type
600 ´ 760 ´ 240mm
Approximately 40kg
Drive enclosure 2.5" type
600 ´ 660 ´ 240mm
Approximately 40kg
3.5" type
600 ´ 660 ´ 240mm
Approximately 40kg
Drive (*1) 2.5" drive
160 ´ 278 ´ 106mm
Approximately 0.5kg
3.5" drive
189 ´ 300 ´ 116mm
Approximately 1.2kg
Power distribution units 1U
570 ´ 710 ´ 160mm
Approximately 4kg
2U
(390 ´ 590 ´ 180mm) ´ 2 (Approximately 7kg) ´ 2
*1: When an order for optional drives to be installed in the factory is placed, enclosures are shipped with
the drives preinstalled.
When optional drives are ordered without preinstallation, each drive is shipped in an individual pack-
age.
Chapter 1 ETERNUS DX Installation
1.4 Package Size
17
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Site Planning Guide
Copyright 2015 FUJITSU LIMITED
P3AM-8982-03ENZ0