Fujitsu ETERNUS DX60 S3 - Figure 1.6 Power Distribution Units (1 U); Table 1.7 Specifications for AC100 V and AC200 V Power Cords; Central American, and Caribbean Regions); Table 1.8 Power Distribution Unit (AC200-240 V, 1 U, 4 Outlets) Specifications

■
AC100V and AC200V Power Cords (for Regions other than the EMEIA, North American, Central
American, and Caribbean Regions)
AC100V/200V power cords are used to connect devices to the IEC60320 C13 power socket type. These power
cords can be used to connect devices with the AC100V and AC200V specifications.
Table 1.7 Specifications for AC100V and AC200V Power Cords (for Regions other than the EMEIA, North American,
Central American, and Caribbean Regions)
Usage Plug type
Socket type
(Socket)
Cable length
Voltage rating/current
rating
Used for connection be-
tween the ETERNUS DX
and the socket
(IEC60320 C13 n
IEC60320 C14)
IEC60320 C14 IEC60320 C13 0.5m
1.0m
1.5m
3.0m
Rating: 250V 10A
(Normal usage rating:
8A)
■
Power Distribution Units (1U) (Only for Regions other than the EMEIA, North American, Cen-
tral American, and Caribbean Regions)
There are four outlets and two inlets.
Figure 1.6 Power Distribution Units (1U)
Two inlets
Four outlets
Table 1.8 Power Distribution Unit (AC200-240V, 1U, 4 Outlets) Specifications
Outlet
Inlet
Voltage rating/current
rating
Socket type
(Socket)
Plug type
Socket type
(Socket)
Cable length
IEC60320 C13 NEMA L6-15P NEMA L6-15R 4.0m Rating: 250V 10A
(Normal usage rating:
8A)
Chapter 1 ETERNUS DX Installation
1.7 Outlet/Socket Specifications
23
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Site Planning Guide
Copyright 2015 FUJITSU LIMITED
P3AM-8982-03ENZ0