10 In the same way, repeat Step 3 through Step 9 to specify the IP address of the other LAN card (B in
Figure 6.1) on the server and the IP address of "CM#1 CA#0 Port#0" (D in Figure 6.1) for the ETERNUS
DX.
11 On the [iSCSI Initiator Properties] screen, click the [Targets] tab.
Confirm whether the specified contents in [The system will look for Targets on following portals] have
been applied correctly before checking connection.
Chapter 6
SAN Connection Settings
6.2 Server Connection Setup
100
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
