Fujitsu Eternus DX600 S3 - Page 363

Chapter 4 Connectivity Management
4.1 Host Affinity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
363
8 After confirming the host affinity settings, click the [Modify] button.
 A confirmation screen appears.
9 Click the [OK] button.
 The modification of the host affinity starts.
10 Click the [Done] button to return to the [Connectivity] screen.
End of procedure
If an error screen appears under the following conditions, check the parameter settings.
• The host interface type of the host and the CA type of the CA port do not match
Note that the CA types of "FCoE" and "FC" are regarded as the same CA type.
• The number of hosts exceeds the maximum number per CA port
• A host cannot recognize some LUNs