Fujitsu Eternus DX80 S2 - Page 146

Appendix A Event Notification Message List
A.2 Message List
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
146
I 01020020 9 – – %d hot spare(s) released These messages are
notified when
"Added/Released
Hot Spare" is
enabled for
Informational Level
in the event
notification setting.
Enclosure=
&a Slot= &b Type= &c
RAID_Group_No=
&d RAID_Group_Name= &e
%d
hot spares are deleted.
%d : Quantity
&a : DE-ID ("00" for a controller enclosure)
&b : Slot number
&c: Type (Global or Dedicated)
&d : RAID group number (only for Dedicated
Hot Spares)
&e : RAID group name (only for Dedicated
Hot Spares)
I 01030010 9 – –
%d volume(s) created These messages are
notified when
"Operated Volume"
is enabled for
Informational Level
in the event
notification setting.
• For Standard volumes, SDVs, or SDPVs
No=
&a Name= &b Type= &c Capacity= &d
RAID_Group_No=
&e RAID_Group_Name= &f
• For TPVs
No=
&a Name= &b Type= &c Capacity= &d
Pool_No=
&g Pool_Name= &h
%d
volumes are created.
%d : Quantity
&a : Volume number
&b : Volume name
&c: Volume type
&d : Capacity
&e : RAID group number (only for Standard/
Open volume, SDV, or SDPV)
&f : RAID group name (only for Standard/
Open volume, SDV, or SDPV)
&g : TPP number (only for Standard/Open
volume or TPV)
&h : TPP name (only for Standard/Open
volume or TPV)
I 01030020 9 – –
%d volume(s) deleted
No=&a Name=
&b
%d
volumes are deleted.
This message is not notified when the deletion
reservation function is used to delete the SDPV.
%d : Quantity
&a : Volume number
&b : Volume name
I 01050010 9 – – Power on completed (
$a )These messages are
notified when
"Power off/on Apply
Firmware" is
enabled for
Informational Level
in the event
notification setting.
Detail information is not displayed.
The device status is changed to Ready.
$a : V xx L xx - xxxx (Firmware version)
I 01050020 9 – – Shutdown started
Detail information is not displayed.
Device shutdown has started.
I 01050030 9 – – Controller firmware updated (
$a )
Detail information is not displayed.
Controller firmware version is updated.
$a : V xx L xx - xxxx (Firmware version)
Event type
code
SNMP Trap
Upper: Message
Remarks
Middle: Detail information
Trap
No.
TrapItemId
TrapLink
StatusInfo
Lower: Description