Fujitsu Eternus DX80 S2 - Additional Drive Installation Procedure

Chapter 5 Maintaining Optional Products
5.1 Installing Drives
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
67
■ About shock
5.1.4 Additional Drive Installation Procedure
This section describes how to install additional drives in the ETERNUS DX Disk storage system.
■ For 2.5" drives
Procedure
1 In the [Storage] screen of [Component] on the ETERNUS Web GUI screen, check that all
components of the ETERNUS DX Disk storage system are in normal status.
2 Wear a wrist strap or touch a metal part to discharge the human body’s natural static
electricity.
CAUTION
Do Not
• Do not lay the drives directly on a desk or similar hard surface. Always use a
rubber mat or other soft material to cushion the drives against physical
shocks.
• Do not stack drives or stand drives on end.
• Do not apply external force to the interface connectors.
• Do not knock or drop the drives on hard objects.
CAUTION
Do
• If additional drives are installed in a way other as described here, damage
and/or device failure or electrical shock may occur.
Do Not
• Do not install drives that are for use in other devices.