Fujitsu Eternus DX80 S2 - Page 102

Chapter 5 Setup
5.1 Basic Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
102
5.1.5.2 Volume Creation
Create volumes (areas in the drives of a RAID group) in the RAID group.
The procedure to create a volume is as follows:
Procedure
1 Click the [Volume] tab on the navigation of the ETERNUS Web GUI screen.
The [Volumes] screen appears.
2 In [Action], click [Create].
The [Create Volumes] screen appears.
3 Select "Automatic" or "Manual" for "RAID Group / TPP Selection".
For regions other than EMEA&I, this setting is not required when the volumes are set with the factory default
settings. To change the factory default settings, delete the factory settings (LUN mappings and volumes) and
then create your own volumes. For details on deleting factory settings, refer to "ETERNUS Web GUI User's
Guide".
CAUTION
Do Not
• Do not uninstall the drives that are installed by default or move them to any
other slot.
Contact your sales representative or maintenance engineer if drives that are
installed by default need to be uninstalled or moved to another slot.