Chapter 5 Setup
5.1 Basic Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
116
The LUNs that are to be registered in the LUN group and the information for the volumes that are
allocated to the LUNs are displayed.
5 Click the [Create] button.
A confirmation screen appears.
6 Click the [OK] button.
The LUN group is added and the setting completion screen appears.
7 Click the [Done] button.
The screen display returns to the [LUN Group] screen.
5.1.6.5 Host Affinity Creation
Create an association between a host group and a CA port group and an association between a host group and
a LUN group to enable the host to recognize a LUN group.
The procedure to create a host affinity is as follows:
1 Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the
[Connectivity] screen, click "Create Host Affinity" in [Action].
The [Create Host Affinity] screen appears.
2 Select the connection target from "Host Group - CA Port Group" in "Target Connection".
To Next Page
Loading...
