Fujitsu Eternus DX80 S2 - Installing Power Distribution Unit (for Regions Other than EMEA&I); Installing Power Distribution Unit (1 U)

Chapter 3 Rack Installation
3.1 Installing Power Distribution Unit (For Regions other than EMEA&I)
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
48
3.1 Installing Power Distribution Unit (For Regions other than
EMEA&I)
This section describes how to install the power distribution unit in a rack.
3.1.1 Installing Power Distribution Unit (1U)
This section describes how to install the 1U power distribution unit in a rack.
Procedure
1 Remove the two brackets temporarily attached to the power distribution unit.
Remove the two M3 screws from the front of the power distribution unit to free the brackets.
2 Attach the brackets and holders to the rack.
CAUTION
Do Not
• Do not connect any devices other than the ETERNUS DX Disk storage system to
the power distribution unit.
Power distribution unit
Bracket B
Bracket A
M3 screw
M3 screw
(Rear rack pillars)
Bracket B
Screw
holders
M6 screws
Screw
holders
Bracket A
Holder
Holder
M6 screws