Chapter 3 Configuration Settings and Display
3.3 RAID Group Management
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
111
3.3 RAID Group Management
This chapter explains the commands used for the following settings:
• RAID group settings
• Hot spares settings
• ECO mode settings
3.3.1 RAID Group
This section explains the commands used for RAID group management.
All disks contained in a RAID group must be the same disk type.
The functions to control RAID groups are as follows:
• Creating a RAID group
• Deleting RAID groups
• Changing an existing RAID group
• LDE, Logical Device Expanding (expanding a RAID group)
To Next Page
Loading...
