Fujitsu Eternus DX80 S2 - Create Raid-Group

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > create raid-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
112
create raid-group
This command creates a RAID group with the specified RAID group name, RAID level and disks. When
registering a hot spare, refer to the "set global-spare" or the "set dedicated-spare" command.
■ Syntax
■ Parameter
create raid-group -name alias_name -disks disks -level {0|1|5|6|10|50}
[-assigned-cm {0|1|cm0cpu0|cm0cpu1|cm1cpu0|cm1cpu1|cm2cpu0|cm2cpu1|
cm3cpu0|cm3cpu1|cm4cpu0|cm4cpu1|cm5cpu0|cm5cpu1|cm6cpu0|cm6cpu1|
cm7cpu0|cm7cpu1|auto}] [-stripe-depth { 64kb | 128kb | 256kb | 512kb | 1024kb }]
-name This parameter specifies the alias name of a RAID group. Only one name can be specified. For
details, refer to "1.2.4 Alias Name Syntax" (page 20)
.
-disks This parameter specifies which disks will form the RAID group. For details, refer to "1.2.3 Disk
Syntax" (page 19).
-level This parameter specifies the RAID level.
0RAID0
1RAID1
5RAID5
6RAID6
10 RAID1+0
50 RAID5+0
-assigned-cm
Optional. This parameter specifies the assigned controller (CM number) of the specified RAID
group. If "auto" is specified, the fixed controller, which is calculated automatically by the
system, is assigned. If this parameter is omitted, the "auto" mode is set.
For the ETERNUS DX80 S2/DX90 S2:
0 Controller module#0
1 Controller module#1
auto Automatically (default)
For the ETERNUS DX410 S2/DX440 S2 and ETERNUS DX8100 S2:
cm0cpu0 Controller module#0 CPU#0
cm0cpu1 Controller module#0 CPU#1
cm1cpu0 Controller module#1 CPU#0
cm1cpu1 Controller module#1 CPU#1
auto Automatically (default)