Fujitsu Eternus DX80 S2 - Set Eco-Mode

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > set eco-mode
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
129
set eco-mode
This command enables or disables the ECO mode. The ECO mode is a power saving function that will turn off
the disk motor when the disks are not being accessed. The ECO function cannot be used unless the ECO mode
is enabled.
■ Syntax
■ Parameter
■ Example(s)
set eco-mode [-mode {enable | disable}]
-mode Optional. This parameter specifies if the ECO mode is enabled. If omitted, the existing setting
is not changed.
enable ECO mode is enabled.
disable ECO mode is disabled.
The following example enables the ECO mode.
CLI> set eco-mode -mode enable
The following example disables the ECO mode:
CLI> set eco-mode -mode disable